Electric Trim Master: " /it-stec55x/input/electric-trim-sw" (0 = OFF, 1 = ON).Autopilot Master (With Flight Director): " /it-stec55x/input/apfd-master-sw" (0 = OFF, 1 = FD, 2 = AP/FD).Autopilot Master (No Flight Director): " /it-stec55x/input/ap-master-sw" (0 = OFF, 1 = ON).I have included an Autopilot Disconnect in the AP Dialog for ease of use. This is because they are not located on the S-TEC 55X Head Unit. You will need to provide your own Autopilot Master, Electric Trim Master, Electric Trim, Autopilot Disconnect, and CWS Mode switches. The property used for the backlighting on the display is " /controls/lighting/panel-norm".Now you will need to adjust the offsets to position the instrument properly.For example, Instruments is not the same as instruments.Īircraft/MyAircraft/Path/To/Instruments/stec-55x/stec-55x.xml Make sure the case of the letters is correct. Make sure you change the path to EXACTLY MATCH the location of the stec-55x folder. This will be a different file for most aircraft. This is usually Models/Instruments, or Models/Cockpit/Instruments. Copy the stec-55x folder from the 3D folder in the IT-STEC55X folder to the aircraft's instruments folder.Follow this step if you want to use the included 3D Head Unit.Look inside the Systems and gui/dialogs folders. You may need to remove old autopilot dialogs for the IT-STEC55X dialog to appear.Copy the gui folder from the IT-STEC55X folder to the aircraft's folder.Follow this step if you want to use the included dialog.This is the default IT-STEC55X Configuration.Copy and Paste from this file, start at line 6.Finally, add the following anywhere outside :.Open the -set file of the aircraft, and find the area inside.Copy the Systems and Nasal folders from the IT-STEC55X folder to the aircraft's folder.Electric Trim Power: " /systems/electrical/outputs/electrim".Autopilot Power: " /systems/electrical/outputs/autopilot".Make sure your electrical system outputs to the correct properties with at least 8 volts: If you are using a custom systems file, make sure it contains the item. If you are using a custom instrumentation file, make sure it contains the and item. Extract the Archive with WinRAR, 7Zip, or similar. This guide will teach you how to install the IT-STEC55X System to an aircraft.Äownload the latest version of IT-STEC55X.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |